- Sand dredger for gravel pit
- Propellant: None
- Transport dim. (L x W x H) m: 28,3 x 3,97 x 3
- Is visually reviewed, but not fully tested in all functions: Yes
- Engine OK: Yes
- Technical condition (1-5) 5=best: 3
Sand dredger for use in a gravel pit.
NB: Has been used in a "lake" in a gravel pit and is not designed to sail at sea and has therefore not been registered as a ship!!! There are therefore no ship registration documents!!!
Ship hull: Length 28.3 m x Width 3.97 m - and transport height approx. 3 m, when the upper part of the console with the wire winch is "cut off". (extension piece for the hull included, see pictures). Has been sandblasted and primed and painted in 2017.
Winches: 4 pieces for navigation.
Engine: Caterpillar C15 - was replaced with a new one about 8 years ago and has only run 6300 hours!.
Fuel tanks: 2 pieces of 6500 liters each, but currently A 700 liter tank is used (for a day's work) and two compressors on board that suck the fuel in from shore (this method avoids oil spills and environmental damage in the event of a leak in the fuel hose).
The sand suction work can be controlled both manually and automatically, controlled via vacuum and pressure.
Suction pump: Larsen and Carlsen 14" inch in good condition (has a loose replaceable "innards/rotor and membrane" that is easy to change and maintain without major costs) - and flushing pump/flushing system for the flushing head - Working capacity is approx. 200-250m3 of clean gravel and stone per hour.
5 pieces are included: 12 m x 0.406 m pipes, each pipe is mounted on 2 pieces of floating pontoons and each has 2 walkways (NB!: The additional pipes and pontoons shown in the pictures are not included!!!). Suction depth can be increased by installing additional pipes (you can purchase them yourself).
See more pictures and information - as well as other auctions at www.fymasauctions.dk Larsen & Carlsen 28 m Sand Dredger - Sand dredger for gravel pit
